How to Use Tile Leveling System?

Tile installation is an exacting job that is very common to go wrong. Improperly installed tiles can leave you with ugly lippage, a problem that is more banal in premises than you know. If you are grappling with the results of undesirable tile installation at your home or office, you need to start considering your options.

Leaving it alone can bring you back your peace of mind, but it will not make the problem go away or even sweep it out of sight. You can trip on it by accident or lose things down the seam if you are not careful. So, what do you do?

You have already invested a lot of money on tiling. Correcting the gaping seams between tiles does not have to be as expensive. Try the Spin Doctor tile leveling systemto realign your tiles, only perfectly this time. The perfect answer to the problems of non-uniformly set tiles, these systems are quick to install and prevent lippage effectively.

The leveling system have two components, caps and threaded posts. One fits into another and together they pass through and tighten the tile seams aligning the surfaces perfectly. Resultantly, you have uniformly aligned tiles.

How to Use a Tile Leveling System?

Tiling leveling systems come in many shapes, sizes and designs. Since we are talking about the best in the market, let’s focus on how to use the reusable anti-lippage tile leveling system from spin Doctor.

First free spin the top or cap to the tile surface. This can be done using just your index and thumb, the way you open a bottle cork.
Next set the spacer posts between the tiles. This will take some calculations. You need to choose a position best fit for your tile size and layout. The good news is, the Spin Doctor lippage system can be used in a wide variety of tile configurations.
When you position the posts, you must make sure that the post is in direct contact with the tiles. In other words, the spacer and the tiles should be in touch with no mortar in between them.
The threaded pacers need to be put directly under the tiles at the exposed edges. This may take a little time depending upon your tile installation.
Now grab the caps and spin lock them with the treaded posts. Make sure that the caps are gone all the way down to the surface of the tiles.
Turn the caps until the surfaces concerned as well as those adjacent to them are flush.
Now run a scraper over the tiles to see if all the pieces are leveled. If the leveling system was appropriately used, all the tiles should be uniform by now.
Uninstalling the levelers is even easier than using them. When the lippage is cured, just kick the caps and they will come out together with the spacers. Alternately, you can also use a rubber mallet to remove them one by one.

A tile leveling system Lowes can be used to level both floor and wall tiles.